ScooterHacking.org

I have an M365 (non-pro). It was on software version 1.4.0.

I bought a pro screen from Amazon. I know now that it is a purple clone and is basically rubbish. I didn't know this at the time.

I followed the guide on this link:
https://www.spzshop.com/blogs/best-prac ... peed-limit

I flashed DRV155GONKA.ZIP

I was left with a red spanner / wrench sign, error 10 and flashing rear brake light for a few seconds before it shuts down.

Now, M365_downG can connect to my scooter OK but when I click "CHECK VER" it just says "Asking Scooter Version" but doesn't return any scooter info. Therefore, I have no way of flashing any BIN files.

I de-installed my pro screen and re-fitted my original M365 non-screen.

However, M365_downG is still the same, can connect to my scooter OK but when I click "CHECK VER" it just says "Asking Scooter Version" but doesn't return any scooter info. Therefore, I have no way of flashing any BIN files.

Is there anything I can do to bring my scooter back to life?

Hi

You must flash with stlink now. Must be written firmware on esc and dashboard. You find tutorials on Google