I don't have the 3-wire plug from battery to controller-Grn Yel-Wh

[slm1nslm2]

Maybe I should be in Other Scoots since this is for a hover 1 Helios, but hold on....
My scooter came with a bricked display and the controller is the same form factor for as your Xiaomi M365. So I purchased a generic xbot kit with a display etc. The problem is one of the features of the helios is a removable battery. The only wires from the battery are for the charger and the thick plug to the controller. There is a plug I need into the controller with green, yellow, and white wires that I should have and my battery does not.
Is it green = +5v , Yellow = Ground, and white = sensor??. I'm afraid I've destroyed another display by attaching 36v to the green, grnd to the yellow and white to the sensor in the motor.

BTW the overall problem I have is the display only powers up for about a second beeps and turns off.

the pic is not my controller either it just has a good shot of the wire/plug I wish my battery had, something simple im missing?

[slm1nslm2]

I'll answer my own question
Different BMS
The hover 1 helios battery will not work with the M365 board Unless:

I find a "RITA" adapter. That would be good, but it's Back Ordered from Poland....Anyone know where to get one? or make one?
Same as adding an external 2nd battery.

Should be able to just add the Xiaomi M365 BMS but the hover 1 is different.

Prolly need a spot welder a bms and then rebuild the battery.

Scooter is new btw just no warranty