ScooterHacking.org

Hello everybody,

Im sorry for my Bad englisch im from germany. 3 months ago I bought a ninebot es1ld. However, this has no Bluetooth and apparently a different controlboard than the ES1. Now I wanted to remove the 20KmH lock on this scooter. And wanted to ask if there is a custom firmware for this scooter. A Bluetooth dashboard does not connect to the ESC. I have programming experience.

I thank you in advance

Only way to replace controller and display from ES1, cost of about ~50e and DIY your self ;)

Only way to replace controller and display from ES1, cost of about ~50e and DIY your self ;) drift boss

Many thanks for the suggestion, is there really no other way?

es1ld Ninebot has a different console than ES1. And its control board doesn't connect to ESC. Want to fix it yourself? It's risky, take it to a car dealer or service agent, they will help you because they have expertise fleeing the complex

With cheap cost, you should replace controller and display from ES1. But doing it yourself can be risky death run 3d

With cheap cost, you should replace controller and display from ES1. But doing it yourself can be risky death run 3d

You can't simply swap the dashboard and controller from an ES1 to this scooter due to the lack of hall sensor on the motor. This scooter runs a sensorless 3 phase motor with no ble. The pin out, however is the same as the ES1-4 esc
(pcb ESC2-L) and can be flashed using your ST-link 😉