Hacking Ninebot ES1LD

marcel7162
Posts: 1
Joined: Tue Oct 05, 2021 1:14 pm

Hacking Ninebot ES1LD

Postby marcel7162 Tue Oct 05, 2021 1:21 pm

Hello everybody,

Im sorry for my Bad englisch im from germany. 3 months ago I bought a ninebot es1ld. However, this has no Bluetooth and apparently a different controlboard than the ES1. Now I wanted to remove the 20KmH lock on this scooter. And wanted to ask if there is a custom firmware for this scooter. A Bluetooth dashboard does not connect to the ESC. I have programming experience.

I thank you in advance
misiozol
Posts: 24
Joined: Mon Sep 27, 2021 4:04 pm

Re: Hacking Ninebot ES1LD

Postby misiozol Mon Oct 11, 2021 12:32 pm

Only way to replace controller and display from ES1, cost of about ~50e and DIY your self ;)
keithanderson
Posts: 1
Joined: Sat Dec 25, 2021 9:31 am

Re: Hacking Ninebot ES1LD

Postby keithanderson Sat Dec 25, 2021 9:36 am

Only way to replace controller and display from ES1, cost of about ~50e and DIY your self ;) drift boss
Many thanks for the suggestion, is there really no other way?
Swenyly
Posts: 3
Joined: Wed Sep 14, 2022 8:19 am

Re: Hacking Ninebot ES1LD

Postby Swenyly Wed Sep 14, 2022 8:35 am

es1ld Ninebot has a different console than ES1. And its control board doesn't connect to ESC. Want to fix it yourself? It's risky, take it to a car dealer or service agent, they will help you because they have expertise fleeing the complex
jordanlaris
Posts: 1
Joined: Thu Sep 15, 2022 3:14 am

Re: Hacking Ninebot ES1LD

Postby jordanlaris Thu Sep 15, 2022 3:18 am

With cheap cost, you should replace controller and display from ES1. But doing it yourself can be risky death run 3d
CDogg
Posts: 79
Joined: Tue Sep 03, 2019 7:08 am

Re: Hacking Ninebot ES1LD

Postby CDogg Sun Dec 25, 2022 12:24 am

With cheap cost, you should replace controller and display from ES1. But doing it yourself can be risky death run 3d
You can't simply swap the dashboard and controller from an ES1 to this scooter due to the lack of hall sensor on the motor. This scooter runs a sensorless 3 phase motor with no ble. The pin out, however is the same as the ES1-4 esc
(pcb ESC2-L) and can be flashed using your ST-link 😉

Return to “Ninebot ES and E-series”

Who is online

Users browsing this forum: No registered users and 46 guests