flashed with st-link a Ninebot es2 is is correct?
Posted: Thu May 06, 2021 8:36 pm
Good day all
Ive followed the Tuto but I need to know if you can confirm if it was flashed ok with this picture before assembly it
It shows an error but I'm not sure
"warning set WORKAREASIZE 0 " before sourcing nrf51.cfg......
Thanks
Ive followed the Tuto but I need to know if you can confirm if it was flashed ok with this picture before assembly it
It shows an error but I'm not sure
"warning set WORKAREASIZE 0 " before sourcing nrf51.cfg......
Thanks