Reading and writing BMS on NFCP3628B battery

[snooopy365]

Hello,

yes I'm new and yes I mostly did register to find a solution to my problem.
I did read that the SNSC 2.3 1kW battery can not be flashed with an working firmware to remove the "40W" cutout limit.

What I did not find was: Why can it not be flashed? Is there no working BIN file without the limit?
That would be fine for me as long as I can read and write the BMS firmware.

First of all: I did not steal any of these batteries.
But most important I do have 2 NFCP3628B batteries with the HD3629-BMS-A02 board. One of them has a pre production firmware on it, that does not yet have the 40W cutout. So it works totally fine.

I also got an ST Link programmer, but can not get it to read the batterys BMS firmware (but also never used it before, so that might be user error?)

Can someone help me what settings I should use in the STM32 Link Utility and tell me if I'm just connecting the pins wrong?
Or is the BMS really so locked that I can not even connect to it?

So I mostly just want to read the BMS firmware of the "good" battery and write it to the "bad" one.

Thanks very much :)

[andy&deee]

What do you mean "40w"? I have such battery in my scooter. I rewired the black wire and I'm riding..

[CrashedCrash]

Wiring stand right on board:
GRND
CLOCK
SWDIO
3,3V

Here are my results:


bin file:
https://anonfiles.com/7c0fs65fz7/firsttry_bin

[CrashedCrash]

What do you mean "40w"? I have such battery in my scooter. I rewired the black wire and I'm riding..

where do you found the black wire directy from the cells?

[CrashedCrash]

can you share your bin file with the preproduction firmware?

[andy&deee]

What do you mean "40w"? I have such battery in my scooter. I rewired the black wire and I'm riding..

where do you found the black wire directy from the cells?

[Esmirrasnda]

can you share your bin file with the preproduction firmware?

I also want to see this drift boss

[Basia]

who managed to download the firmware for bms? Can you send me a link?

[daisymaria]

To read and write data on a BMS, you typically need physical or remote access to the BMS unit. Access might be through a dedicated connector, a communication protocol, or a wireless interface.
Uno Online

[gpio]

What do you mean "40w"? I have such battery in my scooter. I rewired the black wire and I'm riding..

where do you found the black wire directy from the cells?

Hello,

Thank you for share this.

Do you have problems when is charging?

Best regards