Firmware Ninebot SNSC 2.3. Help
Posted: Tue Aug 23, 2022 1:01 pm
Hello! I want to convert SNSC 2.3 to personal. I connected the controller via STlink, launched STM32, but gives an error that the device was not found. How can this be fixed?
Screenshots of errors
https://dropmefiles.com/lEN8w
13:35:58 : ST-LINK SN : Old ST-LINK firmware/ST-LINK already used
13:35:58 : V2J17S4
13:35:58 : Connected via SWD.
13:35:58 : Connection mode : Normal.
13:35:58 : Debug in Low Power mode enabled.
13:35:59 : Device ID:0x410
13:35:59 : Device family :STM32F10xx Medium-density
13:37:35 : Could not set Option bytes!
Please reset the target and retry.
13:35:48 : Can not connect to the target!
Please select "Connect Under Reset" mode from Target->Settings menu and try again.
13:38:39 : Unexpected error
13:38:40 : Can not connect to target!
Please select "Connect Under Reset" mode from Target->Settings menu and try again.
If you're trying to connect to a low frequency application , please select a lower SWD Frequency mode from Target->Settings menu.
13:38:42 : No target connected
Screenshots of errors
https://dropmefiles.com/lEN8w
13:35:58 : ST-LINK SN : Old ST-LINK firmware/ST-LINK already used
13:35:58 : V2J17S4
13:35:58 : Connected via SWD.
13:35:58 : Connection mode : Normal.
13:35:58 : Debug in Low Power mode enabled.
13:35:59 : Device ID:0x410
13:35:59 : Device family :STM32F10xx Medium-density
13:37:35 : Could not set Option bytes!
Please reset the target and retry.
13:35:48 : Can not connect to the target!
Please select "Connect Under Reset" mode from Target->Settings menu and try again.
13:38:39 : Unexpected error
13:38:40 : Can not connect to target!
Please select "Connect Under Reset" mode from Target->Settings menu and try again.
If you're trying to connect to a low frequency application , please select a lower SWD Frequency mode from Target->Settings menu.
13:38:42 : No target connected