Ninebot G30 error 10
Posted: Wed Aug 25, 2021 4:06 am
Hello guys.
My g30 just turned off while riding on a relatively flat surface and when I turned it on again it displayed error 10. I checked all the cables and the controller itself doesn't show any burn marks. Battery is also fine (blinking blue).
As far as I understand, if dashboard powers up then the problem may reside on firmware side of things.
Could firmware corrupt itself and is it worth it for me to get an ST-LINK programmer and try to restore it or should I just buy a new controller (in that case is there any difference between chinese clones and oem parts?).
Thanks in advance!
P.S. Also checked resistance between motor wires - seems consistently low.
My g30 just turned off while riding on a relatively flat surface and when I turned it on again it displayed error 10. I checked all the cables and the controller itself doesn't show any burn marks. Battery is also fine (blinking blue).
As far as I understand, if dashboard powers up then the problem may reside on firmware side of things.
Could firmware corrupt itself and is it worth it for me to get an ST-LINK programmer and try to restore it or should I just buy a new controller (in that case is there any difference between chinese clones and oem parts?).
Thanks in advance!
P.S. Also checked resistance between motor wires - seems consistently low.