Connecting ST link to max
Posted: Wed Sep 30, 2020 10:22 pm
I have used xiaoflasher a dozen times to flash custom firmware into my gen 1 G3OP with 1500 miles riden. Last time, I made a mistake and flashed firmware that included max speeds for Europe and Denmark. Afterwards, the dashboard began flashing a red 10 and will not turn off.
I have come to the conclusion that I need to solder in a ST link and reset my ESC. I've got an ST link and soldering tools.
My question is where do I connect the 5+ volt from the ST link? I have the ESC completely removed.
I have seen the video of how to flash the G30D but the solder points are in different locations.
Any advice would be much appreciated...
I have come to the conclusion that I need to solder in a ST link and reset my ESC. I've got an ST link and soldering tools.
My question is where do I connect the 5+ volt from the ST link? I have the ESC completely removed.
I have seen the video of how to flash the G30D but the solder points are in different locations.
Any advice would be much appreciated...
