Connecting ST link to max

Tenny
Posts: 4
Joined: Tue Sep 22, 2020 8:29 pm

Connecting ST link to max

Postby Tenny Wed Sep 30, 2020 10:22 pm

I have used xiaoflasher a dozen times to flash custom firmware into my gen 1 G3OP with 1500 miles riden. Last time, I made a mistake and flashed firmware that included max speeds for Europe and Denmark. Afterwards, the dashboard began flashing a red 10 and will not turn off.
I have come to the conclusion that I need to solder in a ST link and reset my ESC. I've got an ST link and soldering tools.
My question is where do I connect the 5+ volt from the ST link? I have the ESC completely removed.
I have seen the video of how to flash the G30D but the solder points are in different locations.
Any advice would be much appreciated...
meister_sd
Posts: 31
Joined: Mon Feb 24, 2020 4:29 am

Re: Connecting ST link to max

Postby meister_sd Fri Oct 02, 2020 5:55 am

Image

Red Circle
Tenny
Posts: 4
Joined: Tue Sep 22, 2020 8:29 pm

Re: Connecting ST link to max

Postby Tenny Fri Oct 23, 2020 12:14 am

So I had no luck soldering the st link to the esc. I ended up buying a new esc on amazon. After that I used nineflasher to reset the serial number. This fixed my scooter. I thought it was dead forever. So happy.

Return to “Ninebot Max”

Who is online

Users browsing this forum: No registered users and 48 guests