ScooterHacking ReFlasher - ESC recovery/downgrade
Re: ScooterHacking ReFlasher - ESC recovery/downgrade
Hello, is it possible to somehow flash DRV on ninebot d18?
Re: ScooterHacking ReFlasher - ESC recovery/downgrade
I solved the problem myself, thanks for your attention!
Re: ScooterHacking ReFlasher - ESC recovery/downgrade
Hello
i made this first time so i can not conekt to Target
I have made all right bud no conection
[ReFlasher] Starting..
Info : auto-selecting first available session transport "hla_swd". To override use 'transport select <transport>'.
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
Info : clock speed 450 kHz
Info : STLINK V2J34S7 (API v2) VID:PID 0483:3748
[ReFlasher] Found ST-Link
Info : Target voltage: 3.270400
Error: init mode failed (unable to connect to the target)
[ReFlasher] Couldn't connect to target
What can i do
i use the board from the pic
The LED´s blink grean and one red LED is on
i hope for help
i made this first time so i can not conekt to Target
I have made all right bud no conection
[ReFlasher] Starting..
Info : auto-selecting first available session transport "hla_swd". To override use 'transport select <transport>'.
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
Info : clock speed 450 kHz
Info : STLINK V2J34S7 (API v2) VID:PID 0483:3748
[ReFlasher] Found ST-Link
Info : Target voltage: 3.270400
Error: init mode failed (unable to connect to the target)
[ReFlasher] Couldn't connect to target
What can i do
i use the board from the pic
The LED´s blink grean and one red LED is on
i hope for help
Re: ScooterHacking ReFlasher - ESC recovery/downgrade
I have use zadig-2.8 for the USB Connection
bud ther is one Mistake
Se Pic Below
Is this the reason ?
No WCID on USB
bud ther is one Mistake
Se Pic Below
Is this the reason ?
No WCID on USB
Re: ScooterHacking ReFlasher - ESC recovery/downgrade
Hello
i made this first time so i can not conekt to Target
I have made all right bud no conection
[ReFlasher] Starting..
Info : auto-selecting first available session transport "hla_swd". To override use 'transport select <transport>'.
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
Info : clock speed 450 kHz
Info : STLINK V2J34S7 (API v2) VID:PID 0483:3748
[ReFlasher] Found ST-Link
Info : Target voltage: 3.270400
Error: init mode failed (unable to connect to the target)
[ReFlasher] Couldn't connect to target
What can i do
i use the board from the pic
The LED´s blink grean and one red LED is on
i hope for help
hey i had the same error.
STM32 ST-LINK Utility v4.6.0 is very likely what you are missing with this tool update the stick without having anything connected after that everything should work as described
Read the instructions that solved my problem.
https://rollerplausch.com/threads/st-li ... ring.4270/
Who is online
Users browsing this forum: No registered users and 9 guests