Search found 3 matches

by cyberguy
Fri Feb 11, 2022 8:29 pm
Forum: Ninebot Max
Topic: [Full Tutorial] How to convert a Ninebot Max (G30) for Personal Use (ESC/BMS/BLE Flashing, Rewiring, and CFW)
Replies: 60
Views: 348431

Re: [Full Tutorial] How to convert a Ninebot Max (G30) for Personal Use (ESC/BMS/BLE Flashing, Rewiring, and CFW)

@fivefingerdiscount -- For Battery: It works on SNSC 2.3 @davemclaren -- For ESC: Pls make sure your cables has good connection with thru hole. If posiible solder top and bottom of the board for good conductivity. You dont need 5 or 3.3 v for esc flashing (also unplug from battery) Use STM32 ST-Link...
by cyberguy
Fri Jan 28, 2022 9:14 am
Forum: Ninebot Max
Topic: Wiring snsc 2.3 dashboard
Replies: 9
Views: 8814

Re: Wiring snsc 2.3 dashboard

Hi, SNSC 2.3 (most of all has 2 brake levers) I searched many documents on internet most of all dashboards has 1 socket for brake. It doesn't matter you can use 1 lever sensor connection to the board. Mine has original dashboard on it I was able to change firmware with g30 max firmware. IT's not com...
by cyberguy
Fri Jan 28, 2022 8:59 am
Forum: Ninebot Max
Topic: [Full Tutorial] How to convert a Ninebot Max (G30) for Personal Use (ESC/BMS/BLE Flashing, Rewiring, and CFW)
Replies: 60
Views: 348431

Re: [Full Tutorial] How to convert a Ninebot Max (G30) for Personal Use (ESC/BMS/BLE Flashing, Rewiring, and CFW)

I have 0.5 version as well I manged to upload firmware to battery board use this settings https://i.imgur.com/tGHgjozl.png Board must connect to the battery (+ and -) Check ST-Link pins are correct On battery board square one is 3.3v [ ] 0 0 0 3.3 v - SWIM - GND - RST Also pls check your ST-Link mod...

Go to advanced search